![]() takes up to 2 minutes which on black screen. Up until that point, i tried for 10 minutes to connect. As soon as I shifted the bend in wires to open clip fully, it very easily locked on. I thought I could press the clip on, but indeed you need the swinging action to properly close. RA2 has been upgraded from the inside out to deliver an exceptional experience. Why this matters, you need to use a fully opened clip to lock closed. Since the wire harness is so thick, depending on your bend in the wires, the clip you opened may not have opened widely. The only piece I would share that isn't as obvious is the reconnect of the 52 pin wire harness back on the RA4. The reason being is that with the super cold temps, I was told that pulling the bezel in the very cold, could crack the plastic.ΔΆ014+ Jeep Grand Cherokee Factory GPS Navigation Upgrade! Easy! Radio Removal Installation 2015 2016 I ran the heat in the vehicle for 10 minutes to warm up the vehicle. I purchased the radio from infotainment previously oemautopartco. Attached is the youtube that walks you through the entire process. ![]() entire process took 30 minutes because I was super careful with the vents from bezel to bezel. Did the swap today of a RA2 - factory to a OEM RA4. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |